Choosing Starter Vape Kit mould for distributors

How the price is actually built

If you are comparing three quotes for starter vape kit, compare the paperwork first. Test reports, artwork files, batch coding and the replacement clause tell you more about a supplier than the unit price on page one.

Unit price breaks usually land at 60, 240 and 480 pieces. Between those steps the cost curve flattens, which is why pushing a 200 unit order to 500 often costs less per unit than buyers expect.

Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.

Transit, consolidation and timing

For repeat buyers we hold a shipping schedule rather than shipping on request. A fixed weekly cut-off means your reorder lands before the shelf empties instead of after.

Documentation travels with the goods: commercial invoice, packing list, and the certificate set for your market. We send a scanned copy before dispatch so your broker can clear the file in advance.

What your market will ask for

If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.

Regulation for starter vape kits differs by country and sometimes by state. We do not pretend to be your lawyer, but we do keep the document pack current and we will tell you when a configuration cannot legally enter a market you have named.

• Seven-day defect reporting with replace-or-credit
• Batch codes traceable from carton back to production date
• Cartons drop-tested and pallet-counted for clean freight
• Document pack prepared per destination market
• Private label files archived for future rebrands
• Standing reorder schedule with a fixed cut-off

Batch consistency and why it matters

Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.

Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.

Specification summary

The detail above is what we hold ourselves to on every shipment, including the small ones. It is also the list we will walk through with you before the first order.

Frequently asked

Related reading

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz